Review No:1
December
26, 2023
Owner: Dave
Lebaron
Mailing Address: 2-2806 East Cliff Dr
Santa Cruz CA 95062
Jim Whitney
Mailing Address: 1794 The Alameda San
Jose CA
95126
Jim
Dias
Permit/Eplan: B-237821
/ 527270362
Based upon review of the plans submitted, District requirements have been
met, and
PLANS ARE APPROVED FOR PERMIT.
The amount due for this particular plan review is $115.00.
A
$75.00 late fee may be added to your plan check fees
if payment is not received within 30
days of the date on the corresponding invoice.
To pay online, please visit our District website at centralfiresc.org “Make a Payment” (APN is required).
Otherwise, check payment shall be made payable to Central
Fire District and either dropped off or mailed to the address below.
Community Risk Reduction
930 17th Avenue Santa
Cruz, CA
95062
Fire District fees must be paid, and a receipt for District fees must
be presented to the ?County Planning Department or ?City
of Capitola before Building Permit issuance.
Upon completion of the above listed requirements, please
call the Community Risk Reduction Division to set up an appointment for an
inspection. You will be asked for an address and/or Assessors’ Parcel Number
(APN). A minimum of 48 hours’ notice to the Fire District is required prior to
inspection. The job copies of the building and fire system plans/permits
must be on-site during inspection.
Should you have
any questions regarding the plan check comments, please email me at jimd@csgengr.com. All other inquires may be directed
to Central Fire Districts Community Risk Reduction Division at (831) 685-6698.
As a condition of submittal of these plans, the submitter, designer and
installer certify that these plans and details comply with applicable
Specifications, Standards, Codes and Ordinances, agree that they are solely
responsible for compliance with applicable Specifications, Standards, Codes and
Ordinances, and further agree to correct any deficiencies noted by this review,
subsequent review, inspection or other source.
Further, the submitter, designer, and installer agrees to hold harmless
from any and all alleged claims to have arisen from any compliance
deficiencies, without prejudice, the reviewer and reviewing agency.
|